ABB Acs150 2.2kw 230v 1ph To 3ph Ac Inverter Drive - C3 Emc

ABB Drives ACS 150 AC Frequency Inverter Variable Speed Drive Controller VFD) for 2.2kW (3HP) 230V 3 Ph motor in VxF control to 9.8A. Converts fixed frequency Single Phase 230V input to variable frequency Three Phase 230V output to control the speed of a standard AC Induction motor.

R2 Size - 105mm Wide x 144mm Deep x 169mm high (plus cable clamp plate at 70mm) IP20 case.

Overload - 150% x 60seconds.
Speed Control Range - 0/400Hz without de-rating or 0/500Hz de-rated to 80%
Switching frequency - 4kHz (default) or selectable to 8kHz, 12kHz or 16kHz at 20%, 35% and 50% de-rating.
Braking - To 30 Ohm Minimum, 70 Ohm Maximum external resistor (not supplied) - See the Resistor options linked below or use the 'Which Resistor' button on this page.

Features - Front Mounted Potentiometer, 1 x Analogue Input, 5 Digital Inputs, 1 Relay Contact set.
Programmable from a pc via 'Flashdrop'.
EMC Filters to EN61800-3 to the 2nd Environment C3 (Industrial). See linked products below for external 1st Environment (Domestic) EMC Filter.
Can be used with supplies protected by RCD Type A.

Input Current - 21A, or 15A when supplied via 1mH choke.
Input Voltage - 200/240V single phase +-10% at 50/60Hz.

Wall mount in clean environment or cubicle mount.
Rated at 40C Ambient.
Ventilation space above and below - 75mm.
Ventilation space at sides - 0mm.
Heat Loss at max output - 113W.
Mounting onto symmetrical DIN rail or use the screw fixings for side or rear mounting.

Full part number is - ACS150-01E-09A8-2 (68581991)

Replaces the ACS100 that is no longer manufactured.